Description
Features
Open-weave design with peel-and-stick tape provides fast and easy installation on subfloors
Adds only 1/8 in. thickness to a typical tile floor and is easily adjusted to accommodate curves, angles, and cut-outs
Controlled by a SunStat floor sensing thermostat (sold separately)
Specifications
Supply Voltage: 1-phase
Amp Draw: 1 amp per 10 square feet
Maximum Circuit Load: 20 amps (15 amps with SunStat Control)
Wire Spacing: 3″ o.c.
Maximum Allowable Temperature: 194°F (90°C)
EMF: Less than 1 milligauss at 1/2″ above surface
Insulation: ETFE Fluoropolymer
Ground: Copper
Double-Sided Tape: 3/4″ wide, installed along both edges of mat
Minimum Allowable Bend Radius: 1″
Power Lead Length: 10′
Allowable Substrate
Backer board over wood subfloor
Polymer-modified setting bed over wood subfloor
Polymer-modified setting bed over concrete slab
Thin slab/self-leveling concrete over wood subfloor
Thin slab/self-leveling concrete over concrete slab
Allowable Floor Coverings
Tile/stone
Carpet
Hardwood







Reviews
There are no reviews yet.